 Note
| Removal and installation is described for the front left
speed sensor. Removal and installation of the front right speed
sensor is analogous. |
|
|
|
| – |
Release and disconnect connector -3-
from front left speed sensor -G47--1-. |
| – |
Unscrew bolt -2-, and pull
front left speed sensor -G47--1-
out of wheel bearing housing. |
| Install in reverse order of removal, observing the
following: |
| – |
Before inserting speed sensor, clean inner surface of hole,
and coat speed sensor all-round with high-temperature paste -G
052 112 A3-. |
| → Chapter „Assembly overview - speed sensor on front axle“ |
|
|
|
Questions & answers
Removing and installing speed sensors on front axle -G45-/-G47- — Volkswagen Golf Mk7
How do I remove Golf Mk7 GTE front ABS sensors?
Same as standard: disconnect, unbolt, pull out, clean bore.
1 -
ABS speed sensor
Before inserting sensor, clean inner surface of fitting hole and
coat it with high-temperature paste -G 052 112 A3-.
...
Note
Removal and installation is described for the rear left
speed sensor. Removal and installation of the rear right speed
sensor is analogous.
...
