VW Golf Mk7 manualsGolf Mk7 / manual

Volkswagen Golf Mk7 Service & Repair Manual: Removing and installing turn signal switch -E2-, Valeo

The same combined combination switch -E595- principle applies to the Valeo design — turn signal, cruise control and wiper switches cannot be renewed individually.

  Note
The turn signal switch -E2-, cruise control system switch -E45- and intermittent wiper switch -E22- are combined to form the steering column combination switch -E595-.
These switches cannot be separated.
If one of the switches is defective, the steering column combination switch -E595- must be renewed as a complete unit.
Removing
–  Remove steering column electronics control unit -J527- → Chapter.
   

Removing and installing turn signal switch -E2-, Valeo

–  Press release button -1- on each side in direction of arrow -A-.
–  Pull off steering column combination switch -E595--2- slightly.
–  Release retaining tab -3- in direction of arrow -B-.
–  Pull off steering column combination switch -E595--2-.

 
Installing
Installation is carried out in the reverse sequence.
 

    Questions & answers

    Removing and installing turn signal switch -E2-, Valeo — Volkswagen Golf Mk7

    How do I remove the Golf Mk7 Valeo turn signal stalk?
    Same pull-out method, different release tab position.
    Removing and installing turn signal switch -E2-, Kostal
      Note The turn signal switch -E2-, cruise control system switch -E45- and intermittent wiper switch -E22- are combined to form the steering column ...

    Removing and installing cruise control system switch -E45
      Note t  The turn signal switch -E2-, cruise control system switch -E45- and intermittent wiper switch -E22- are combine ...