Volkswagen Golf Mk7 Service & Repair Manual: Removing and installing parking aid control unit -J446-, left-hand drive vehicle

Note: select "Renew" via Guided Fault Finding when replacing this control unit. This page covers removing parking aid control unit -J446- on LHD models — remove the trim under the dash panel first.

Note When renewing the control unit, select Renew function for the respective control unit in Guided fault finding or Guided functions mode → Vehicle diagnostic tester. Removing –  Remove trim under dash panel → General body repairs, interior; Rep. gr.68.

–  Disconnect connectors -1 and 2-.

–  To do so, press locking detent -1-, swing retainer in -direction of arrow- and pull off connector. –  Disengage retaining tab -arrow- and remove control unit -3- downwards from retainer. Installing Installation is carried out in the reverse sequence.

Questions & answers

Removing and installing parking aid control unit -J446-, left-hand drive vehicle — Volkswagen Golf Mk7

How do I remove the Golf Mk7 ParkPilot control unit -J446- (LHD)?

Behind the front bumper or under the dash. Disconnect connector, unbolt and remove. New unit must be coded.

Assembly overview - rear parking aid, RHD vehicles

1 -  Electrical connector 2 -  Spreader clip 3 -  Rear parking aid warning buzzer -H15- Removing and inst ...

Removing and installing parking aid control unit -J446-, RHD vehicle

  Note When renewing the control unit, select Renew function for the respective control unit in Guided fault finding or Guided functions mode &# ...

Other materials:

• Assembly overview - front parking aid, RHD vehicles
• Assembly overview - rear parking aid, LHD vehicles
• Assembly overview - front parking aid, LHD vehicles
• Removing and installing rear parking aid senders
• Removing and installing rear parking aid warning buzzer -H15-