 Note
| When renewing the control unit, select
Renew function for the respective control unit in
Guided fault finding or
Guided functions mode
→ Vehicle
diagnostic tester. |
| – |
Remove dash panel end trim on driver side
→ General body repairs, interior; Rep. gr.68. |
| – |
Remove driver side knee airbag
→ General body repairs, interior; Rep. gr.69. |
|
|
|
| – |
Release spreader clip -3- and
pull it out. |
| – |
Remove headlight range control unit
-1- towards rear. |
| – |
Disconnect electrical connector -2-. |
|
|
|
| – |
To do so, press locking detent -1-,
swing retainer in -direction of arrow-
and pull off connector. |
| Install in the reverse order of removal, observing the
following: |
|
|
|
| – |
Press spreader clip -2- into
opening -3- in control unit
-1-. |
| – |
Engage spreader clip by turning it 90°
-arrow-. |
|
|
|
Questions & answers
Removing and installing headlight range control unit -J431-/control unit for cornering light and headlight range control -J745-, LHD vehicles — Volkswagen Golf Mk7
How do I remove the Golf Mk7 headlight range control unit (LHD)?
Under the dash panel. Disconnect, unbolt and remove. A new unit must be coded. -J745- also controls cornering lights.
1 -
Control unit
Removing and installing
→ Chapter
Versions without cornering light:
Headlight range control un ...
Note
When renewing the control unit, select
Renew function for the respective control unit in
Guided fault finding or
Guided functions mode
&# ...
Assembly overview - automatic headlight range control, RHD vehicles
Removing and installing headlight range control unit -J431-/control unit for
cornering light and headlight range control -J745-, RHD vehicles