Using removal wedge -3409-, this page covers removing the anti-theft sensor -G578- (4-bolt version) — Caution: mask visible surfaces when using leverage tools.
| Special tools and workshop equipment
required |
|
|
|
Caution
| Danger of damage to component surfaces. |
| When using leverage tools, mask visible areas of the
component with commercially available adhesive tape. |
|
| – |
Remove front interior light -WX1-
→ Chapter. |
|
|
|
| – |
Using removal wedge -3409-, lever off cover
-1- in vicinity of
-arrows-. |
| – |
Remove roof module -2-. |
| – |
Disconnect electrical connector. |
|
|
|
| – |
Release retaining tabs in direction of arrows
-A- and -B-. |
| – |
Remove anti-theft alarm sensor -G578--1-
from roof module. |
|
|
|
| – |
Release retaining tabs in direction of arrows
-A- and -B-. |
| – |
Remove single sensor -1- from
roof module. |
| Install in the reverse order of removal, observing the
following: |
 Note
| The anti-theft alarm sensor -G578- needs to be parameterised
after renewal. |
| – |
Parameterise anti-theft alarm system sensor -G578-
→ Vehicle diagnostic tester. |
| → Chapter „Assembly overview - interior monitor“ |
|
|
|
Questions & answers
Removing and installing anti-theft alarm sensor -G578-, version with 4 bolts — Volkswagen Golf Mk7
How does Golf Mk7 alarm sensor -G578- removal differ (4-bolt)?
Four bolts instead of two. Otherwise same headliner access and disconnection procedure.
Removing
–
Remove front interior light -WX1-
→ Chapter.
–&n ...
Removing and installing front camera for
driver assist systems
Removing
–
Switch off ignition and all electrical ...
Removing and installing anti-theft alarm sensor -G578-, version with 2 bolts
Front camera for assist systems