With the battery earth cable disconnected, this page covers removing fuse holder B -SB- — press the release tabs and detach the engine compartment electronics box cover.
| – |
With ignition switched off, disconnect earth cable from
battery
→ Chapter. |
|
|
|
| – |
Press release tabs -arrow- and
detach cover -1- for electronics
box (engine compartment). |
|
|
|
| – |
Release retaining tab -2- using
a screwdriver and pull off front cover -1-
upwards -arrow-. |
|
|
|
| – |
Mark allocation of electrical wiring at threaded connections
for reinstallation. |
| – |
Unscrew nuts -1, 2, 4, 5 and 6-. |
| – |
Move electrical wiring clear -arrow-. |
|
|
|
| – |
Cut through cable tie (bottom) on wiring harness. |
| – |
Release fasteners -1, 2 and 4--arrow-,
remove fuse holder B -3- and lay to
one side. |
| Install in the reverse order of removal, observing the
following: |
| – |
Fit and secure electrical wiring to fuse holder A according
to markings made earlier. |
| – |
Connect battery
→ Chapter. |
| → Chapter „Overview of fitting locations – relay carriers, fuse
holders, electronics boxes“ |
|
|
|
Questions & answers
Removing and installing fuse holder B -SB- — Volkswagen Golf Mk7
How do I remove Golf Mk7 fuse holder B -SB-?
Unclip from inside the E-box and remove. Replace with the correct rating fuse holder.
Removing
–
With ignition switched off, disconnect earth cable from
battery
→ Chapter.
Diesel en ...
Removing
–
Remove fuse holder B
→ Chapter.
–
Take securing bar -4- out of
fuse ho ...
Removing and installing electronics box (E-box)
Removing and installing fuse holder A -SA-