VW Golf Mk7 manualsGolf Mk7 / manual

Volkswagen Golf Mk7 Service & Repair Manual: Removing and installing wiper motor -V-

Using torque wrenches -V.A.G 1410-/-V.A.G 1331-, this page covers removing the Volkswagen Golf Mk7 wiper motor -V- with control unit -J400- — start the renewal function if the unit is being replaced.

Special tools and workshop equipment required
   
Torque wrench -V.A.G 1410-
 

Removing and installing wiper motor -V-

Torque wrench -V.A.G 1331-
  Note
If the wiper motor -V- with the wiper motor control unit -J400- is to be renewed, start the respective function → Vehicle diagnostic tester.
The removal and installation procedures are described for LHD vehicles. Removal and installation for RHD vehicles are similar.
Removing
–  Removing wiper arms → Chapter.
–  Remove left plenum chamber cover → General body repairs, exterior; Rep. gr.50.
 

Removing and installing wiper motor -V-

–  Remove bolts -1, 3, 4-.
–  Disconnect electrical connector -5-.
–  If fitted, disconnect connector for damper control.
–  Take wiper frame -2- with linkage and wiper motor out of plenum chamber.
Installing
Install in the reverse order of removal, observing the following:
–  Adjust wiper arms → Chapter.
Specified torques
→ Fig. „“Removing and installing wiper motor – specified torque and tightening sequence”“
 

Removing and installing wiper motor -V-

    Questions & answers

    Removing and installing wiper motor -V- — Volkswagen Golf Mk7

    How do I remove the Golf Mk7 wiper motor -V-?
    Remove the plenum covers and wiper arms. Unbolt the motor/frame assembly from the body, disconnect the connector and remove as a unit.
    Adjusting wiper arms
    Special tools and workshop equipment required     Torque wrench -V.A.G 1331-   Note ...

    Renewing wiper motor
    Special tools and workshop equipment required     Release lever -80-200-   ...

    Other materials: