 Note
| When renewing the control unit, select
Renew function for the respective control unit in
Guided fault finding or
Guided functions mode
→ Vehicle
diagnostic tester. |
| – |
Remove ignition key, if inserted. |
| – |
Remove glove compartment
→ General body repairs, Interior; Rep. gr.68. |
|
|
|
| – |
Disconnect connectors -1, 2 and 3-. |
|
|
|
| – |
Press locking detent -1- to
disconnect connectors. |
| – |
Swing retainer in -direction of arrow-
and pull off connector. |
|
|
|
| – |
If present, remove guide -2-.
To do so, release fasteners on guide in direction of arrow
-A-. |
| – |
Remove guide -2- from onboard
supply control unit -J519--1- in
direction of arrow -B-. |
|
|
|
| – |
Release retaining spring at top -2-
in direction of arrow -A-. |
| – |
Pull onboard supply control unit -J519--1-
towards rear -arrow B- out of
bracket. |
| Installation is carried out in the reverse sequence. |
|
|
|
Questions & answers
Removing and installing onboard supply control unit -J519-, RHD vehicles — Volkswagen Golf Mk7
How do I remove the Golf Mk7 -J519- (RHD)?
Mirrored access. Same coding requirement.
Note
When renewing the control unit, select
Renew function for the respective control unit in
Guided fault finding or
Guided functions mode
&# ...
Note
When renewing the control unit, select
Renew function for the respective control unit in
Guided fault finding or
Guided functions mode
&# ...
Removing and installing onboard supply control unit -J519-, LHD vehicles
Removing and installing data bus diagnostic interface -J533-