Volkswagen Golf Mk7 Service & Repair Manual: Removing and installing dip beam screen motor -V294-/-V295

Note: the dip beam screen motors -V294-/-V295- are only fitted on gas discharge headlights without cornering light — this page covers their location inside the headlight and removal.

Note Left dip beam screen motor -V294- and right dip beam screen motor -V295- are only fitted on gas discharge headlights without cornering light. The dip beam screen motor is located in the headlight and cannot be renewed separately in the event of a fault. –  Removing and installing headlights → Chapter.

Questions & answers

Removing and installing dip beam screen motor -V294-/-V295 — Volkswagen Golf Mk7

How do I remove the Golf Mk7 dip beam screen motor?

Remove the headlight. Unbolt the motor from inside the housing. The motor drives the shutter that creates the dipped beam cut-off line.

Removing and installing LED modules for daytime running light and side light -L176-/-L177- (“GTE” only)

Special tools and workshop equipment required     Torque wrench -V.A.G 1783-   ...

Removing and installing bulbs for cornering light -L148-/-L149-

  Note Left cornering light bulb -L148- and right cornering light bulb -L149- are only fitted on gas discharge headlights. R ...

Other materials:

• Removing and installing daytime running light bulb -L174-/-L175-, gas discharge headlights
• Removing and installing headlight range control motor -V48-/-V49- (gas discharge headlights)
• Assembly overview - gas discharge headlight with cornering light and LED daytime running light
• Assembly overview - dual halogen headlight
• Removing and installing LED modules for daytime running light and side light -L176-/-L177- (does not apply for “GTE”)