Using torque wrench -V.A.G 1410-, this page covers removing the valveless sensor, customer service version — check which variant is fitted before proceeding on this Volkswagen Golf Mk7.
| Special tools and workshop equipment
required |
|
|
|
| Torque wrench -V.A.G 1410- |
| Carry out the following work: |
| – |
Remove tyre from wheel
→ Chapter |
|
|
|
| Be sure to check which version is installed, before
performing further work. |
| I - Customer service version |
| In the customer service version, the tyre pressure sensor is
secured on the valve by means of a torx socket bolt
-1-. |
| If the customer service version is installed, the following
work sequence applies
→ Anchor. |
| In case of the production version, the tyre pressure sensor
is secured on the valve by means of a flat square head bolt
-2-. |
| If the production version is installed, the following work
sequence applies
→ Anchor. |
|
|
|
| – |
Unscrew bolt -arrow- for tyre
pressure sensor -1-. |
| – |
Counter hold on metal valve (for example using 2 mm twist
drill). |
Caution
| Before installing tyre pressure sensor, clean valve
hole. |
|
|
|
|
| – |
Press tyre pressure sensor -1-
against wheel rim and tighten -arrow-. |
| – |
Counter hold on metal valve (for example using 2 mm twist
drill). |
 Note
| After fitting, carry out a visual inspection and check that
it is securely seated. The tyre pressure sensor
-1- must be bolted such that there
is no play, and its support feet must be located in the drop
centre of the rim. |
| The bolt must not be retightened to specified torque after
the installation has been completed. |
| → Chapter „Assembly overview - tyre pressure sensor, tyre
pressure sensor without valve“ |
|
|
|
Questions & answers
Removing and installing tyre pressure sensor, tyre pressure sensor without valve, customer service version — Volkswagen Golf Mk7
How do I remove a Golf Mk7 clamp-mounted TPMS sensor (service version)?
Remove the tyre. Unscrew the clamp band, lift the sensor off the rim well and remove. Position the new sensor at the valve position for balance.
Removing
–
Unscrew union nut -1-.
–
Remove tyre pressure sensor- ...
Special tools and workshop equipment
required
Torque wrench -V.A.G 1410-
Ca ...
Removing and installing tyre pressure sensor, tyre pressure sensor with
valve
Removing and installing tyre pressure sensor, tyre pressure sensor without
valve, production version