WARNING
| Risk of death due to high voltage! Risk of injury
and environmental pollution! |
| Observe operation and safety notes for gas discharge
bulbs
→ Chapter. |
| It is essential that the battery earth cable is
disconnected before any work on parts of the gas
discharge headlight is performed. The parts are marked
with a yellow high voltage symbol. |
|
 Note
| Output module for left headlight -J667- and output module
for right headlight -J668- are only fitted on gas discharge
headlights with cornering light. |
| Removal and installation are described for the left side.
Removal and installation on the right side are carried out in
the same way. |
| – |
Remove headlight
→ Chapter. |
|
|
|
| – |
Pull output module for left headlight -J667--1-
off headlight. |
| – |
Press release button -4-. |
| – |
Disconnect electrical connector -3-. |
| Install in the reverse order of removal, observing the
following: |
Caution
| Make sure seal is correctly seated when installing
the gas discharge bulb control unit. The ingress of
water will lead to permanent damage to the headlight. |
|
| – |
Check seal between control unit and headlight for damage. |
| → Chapter „Assembly overview - headlight“ |
|
|
|
Questions & answers
Removing and installing output module for headlight -J667-/-J668- — Volkswagen Golf Mk7
How do I remove the Golf Mk7 headlight output module?
Remove the headlight. Unbolt the module from inside the housing and disconnect.
WARNING
Risk of death due to high voltage! Risk of injury
and environmental pollution!
...
WARNING
Risk of death due to high voltage! Risk of injury
and environmental pollution!
...
Removing and installing gas discharge bulb control unit -J343-/-J344-
Removing and installing control unit for daytime running light and side
light -J860-/-J861-