 Note
| Left headlight dipped beam bulb -M29- and right headlight
dipped beam bulb -M31- are only fitted on dual halogen
headlights. |
| Removal and installation are described for the left side.
Removal and installation on the right side are carried out in
the same way. |
|
|
|
| – |
Turn housing cover -1- in
direction of arrow -A-. |
| – |
Remove housing cover -1-. |
|
|
|
| – |
Turn bulb holder -1- in
direction of arrow -A- until
locking lug -3- is in recess
-2-. |
| – |
Pull out bulb holder -1- in
direction of arrow -B-. |
|
|
|
| – |
Pull bulb -1- out of bulb
holder -2-. |
| Install in the reverse order of removal, observing the
following: |
Caution
| Risk of damage to the headlight. |
| Do not touch the glass part of the bulb with bare
fingers. Fingers leave traces of grease on the glass
bulb, which vaporise when the bulb is switched on and
cause the glass bulb to cloud over. |
| Wear, for example, clean fabric gloves when
inserting bulbs. |
| Make sure the housing cover is correctly seated when
installing. The ingress of water will lead to permanent
damage to the headlight. |
|
| – |
Insert new bulb into bulb holder. |
| – |
Insert bulb holder into reflector whilst ensuring that
locking lug points upwards and fits into recess. |
| – |
Check headlight setting and adjust headlight if necessary
→ Booklet36.1 |
|
|
|
Questions & answers
Removing and installing headlight dipped beam bulb (dual halogen headlights) — Volkswagen Golf Mk7
How do I change the Golf Mk7 halogen dipped beam bulb?
Remove the cover behind the headlight, twist the H7 holder, pull out, swap bulb (do not touch glass) and refit.
Special tools and workshop equipment
required
Torque screwdriver -VAS 6494-
Not ...
Special tools and workshop equipment
required
Front-end hook -3370-
...
Removing and installing headlight range control motor -V48-/-V49-, LED
headlights
Removing and installing headlight dipped beam bulb (LED)