 Note
| Removal and installation are described for the left side.
Removal and installation on the right side are carried out in
the same way. |
|
|
|
| – |
Pull off housing cover -1- in
direction of arrow -A-. |
|
|
|
| – |
Turn grip -1- in direction of
arrow -A- until contacts are
disconnected from connector housing -2-. |
| – |
Pull out grip -1- in direction
of arrow -B-. |
|
|
|
| – |
Pull bulb -2- out of grip
-1-. |
| Install in the reverse order of removal, observing the
following: |
Caution
| Risk of damage to the headlight. |
| Do not touch the glass part of the bulb with bare
fingers. Fingers leave traces of grease on the glass
bulb, which vaporise when the bulb is switched on and
cause the glass bulb to cloud over. |
| Wear, for example, clean fabric gloves when
inserting bulbs. |
| Make sure the housing cover is correctly seated when
installing. The ingress of water will lead to permanent
damage to the headlight. |
|
| – |
Check headlight setting and adjust headlight if necessary
→ Booklet36.1 |
|
|
 |
Questions & answers
Removing and installing headlight main beam bulb -M30-/-M32- (dual halogen headlights) — Volkswagen Golf Mk7
How do I change the Golf Mk7 halogen main beam bulb?
Remove the cover, twist the H15 holder, swap the bulb and refit. The H15 also provides daytime running light.
Special tools and workshop equipment
required
Front-end hook -3370-
...
Note
Removal and installation are described for the left side.
Removal and installation on the right side are carried out in
the same way.
...
Removing and installing headlight dipped beam bulb (LED)
Removing and installing headlight main beam bulb -M30-/-M32- (dual halogen
headlights)