VW Golf Mk7 manualsGolf Mk7 / manual

Volkswagen Golf Mk7 Service & Repair Manual: Routing and securing wiring

This page requires marking Volkswagen Golf Mk7 lines before removal — to prevent them being interchanged and to guarantee correct reinstallation — applying to fuel, hydraulic, vacuum and electrical lines alike.

Mark lines prior to removal to prevent them from being interchanged and to ensure that they are fitted in their original positions. This applies for fuel, hydraulic and vacuum lines as well as lines for activated charcoal filter system and electrical wiring. Where necessary, make sketches or take photographs.
Due to the limited space in the engine compartment, it is important to ensure that there is adequate clearance to any moving or hot components to avoid damage to lines and wiring.

    Questions & answers

    Routing and securing wiring — Volkswagen Golf Mk7

    What wiring routing rules apply to the Golf Mk7?
    Route away from hot surfaces and moving parts. Use original clip positions. Do not stretch or kink looms. Secure with cable ties at factory positions.
    Contact corrosion
    Contact corrosion can occur if unsuitable fasteners (bolts, nuts, washers, etc.) are used. Therefore, only fastening elements with a special surface ...

    Battery
    Battery - general notes   Note All instructions and notes regarding this chapter are available under → Electrical Syste ...

    Other materials: